Heatit

The Heatit Z-Wave is an electronic thermostat for floor heating in a standard wall box. The thermostat has a built-in Z-Wave chip that can be connected with Home Automation systems like Fibaro, Future Home,

The Heatit Z-Wave is an electronic thermostat for floor heating in a standard wall box. The thermostat has a built-in Z-Wave chip that can be connected with Home Automation systems like Fibaro, Future Home,

External room sensor, glass front NTC 10 k?

Additional temperature sensor for Heatit thermostats. 10Kohm. Needs wiring.

The module can be power supplied from a 230V AC mains connection, and is able to deliver an output supply of 24V DC. Heatit Z-Water relay outputs are able to be freely controlled from the Z-Wave network, and can be used for several purposes, e.g. on/off c

Heatit Extra floor sensor for Z-Water or Heatit thermostat.

Heatit Z-TRM2fx is an electronic thermostat for electrical floor heating. The thermostat has a built-in Z-Wave chip that can be connected with Home Automation systems like Fibaro, Futurehome, Smarthings, Homeseer, Vera, Zipato etc.

Heatit Z-TRM2fx is equipped with a single pole switch and it fits most System 55 frames (Elko RS16, Schneider Exxact, Gira, Jung etc.). The thermostat can withstand a load of max 13A /2900W at 230V. At higher loads the thermostat must control a contactor. The thermostat may be connected to two wired external sensors.

The thermostat has the capacity of up to 5 associations (relays, wall plugs etc.).

Heatit Z-Push Button 8 is a battery operated wall switch with 8 push buttons. The switch enables you to control the Z-Wave-products in your smart home system. Managing your Z-Wave products becomes easy and practical. The switch can be set up to control scenarios or work in associations with other Z-Wave products.


Heatit Z-Push Button 8 can control up to 4 seperate association groups with up to 20 products or up to 16 scenarios through your gateway.

Heatit Z-Push Button 8 may not be used as a stand-alone unit; it must be included in a gateway to function.

The switch fits into standard Elko, Schneider Exxact and Gira System 55 frames.

The switch is easy to installed, and may be fastened with screws or double-sided tape.

Heatit Z-Push Button 2 is a battery operated wall switch with 2 push buttons. The switch enables you to control the Z-Wave-products in your smart home system. Managing your Z-Wave products becomes easy and practical. The switch can be set up to control scenarios or work in associations with other Z-Wave products.


Heatit Z-Push Button 2 can control 1association group with up to 5 products or 4 scenarios through your gateway. Heatit Z-Push Button 2 may not be used as a stand-alone
unit; it must be included in a gateway to function. The switch fits into standard Elko, Schneider Exxact and Gira System 55 frames. The switch is easy to installed, and may be fastened with
screws or double-sided tape.